Supa Glue
“INSTANT BONDING, NO CLAMPING REQUIRED” Bonds most non-porous materials. Dries colourless and sets within 10 seconds. (Maximum bond strength in 12 hours). Heat and water resistant. One drop holds one tonne, provided the bond area exceeds 650mm2 and there is no gap between surfaces. Not suitable for use on paper, leather, polyethylene or Teflon. Will not permanently bond glass or materials containing alkaline elements. Note: Not recommended for repairing handles of vessels containing hot liquids.
 |
- Dries colourless
- Heat and water resistant.
|
|
|
 |
- Remove nozzle and pierce tube seal with reverse end of cap and replace nozzle.
- Surfaces to be bonded must be clean and fix exactly. Apply one drop to only one of the surface to be bonded.
- Do not spread, align surfaces and apply slight pressure.
- Allow several minutes to set and for bond strength leave it up to 12 hours.
|
|
|
 |
- Avoid contact with skin, eyes and avoid breathing vapour.
- If skin contact occurs, apply solvent such as acetone to contact areas then wash off with water.
- Do not use solvents near eyes or open wounds.
- In case of eye contact, immediately flush with water.
|
|
